Ordered these to replace the old original rusted out burners on my BGB-30 grill. For the price, these cannot be beat but beware that some modification may be required. Both burners required the rear tabs that hold the burner in place to be modified. The tabs on these were about an 1/8 of an inch too close, so I took my dremmel and cut out a notch on the tabs that would allow them to seat properly. The left burner immediately fit into place and worked like a champ.The right burner was a big PITA. Not only did I have to modify the rear tabs, but the front tabs were causing the burner to not make proper contact with the gas orifice. Once again I took my dremmel and about 6 cutting wheels to cut about an 1/8th of an inch from the front of both tabs. After that, the burner slid into place.Overall for the price, I can't complain about the necessary modifications.What a deal!!! Great price, well made... I'm thrilled to find these to rebuild my DCS. Very pleased. After getting my hands on these i can say outstanding value.Durability. I'll have to tell you in 3 or 4 years but at this price won't be a problem.rotted out after 3 years.Just replaced many components on my DCS built in BGB30-BQR grillthe following worked great, the only thing I had to modify the burner replacement by grinding the inside tabs a bit for a good fit- Direct store Parts DP111 (3-pack) Stainless Steel Heat plates Replacement DCS Gas Grill (3)- Direct store Parts DA109 (3-pack) Stainless Steel Burner Replacement Charmglow, DCS, Gas Grill (3)- Hongso 17Y-New CR123-3 Universal Gas Grill Ceramic Radiants, BBQ Grill Ceramic Rods Replacement 9.5" for DCS Heat Plates, for DCS Grill 245398, DCSCT (3-pack)Not as heavy gauge as my previous burners and found they are made of two different grades of stainless, the u-tube is magnetic and the jet tube is not. The u-tube could be a 17 to 18 series stainless steel, has some carbon in it, which could rust. The tabs were too close together to fit into my DCS burner holders, so I had to grind some off the inside of the tabs to fit. For the price, I could afford to change them once a year.Look like the originals, however the front (loop side) tabs did not fit properly (set too close together) Modified tabs with zip tool and reduced size of tab so they now fitBGB 30 compatible. Had to trim end tabs app 3/8" as they were to close together. Made in China. Great deal compared to original equipment manufactured. Liked that it has screens over the air intake to try to keep spiders out.I used these replacement burners for my DCS 30" grill. these burners fit fantastic with just a little tweaking of the front placement clips...I used a plier to bend them a bit and they fit just perfect. Material is high quality and very sturdy...extremely happy with the ease of replacing and most of all the price. My grill only needs two burners and this set comes with three....bonus for me